Window
Service Install
Find All information about Window Installation Service
How to Replace a Window
Most of the homeowners considered to do it yourself window replacement or installation Process. The level of skill that is needed for window replacement depends on the type of Project. The right tools for the window replacement include safety glasses, caulk gun, waterproof shims, tape measure, level, hammer, power drill, screwdriver, utility knife, and a small Pry bar.
Window installation service if you want to replace the whole window you have to consider the use of a stock replacement window. You have to make an adjustment for the frame and by using a crowbar you would be able to remove the entire window casing including trim and still plate.
Adjust window frame by using the window casing but you have to make sure that the headers and studs are Plum and square and the selected frame is best suitable according to the dimension of the new window. This procedure requires the addition of a new board and removing part of the siding on the exterior. Allow about 1/4 inch gap on all sides for further adjustments and insulation. Install a new window and if the exterior siding had to be removed you have to put felt wrap back up for keeping the moisture out.
if you don't want to take a
window installation service you should start the
installation process at the bottom of the window. Install the window by pushing
it up until it will be flush to the frame. Screw your window by adjusting it in
the correct position. Once the window will be fitted you have to use the screw
it in the right place. Wrap the window its surface. You don't have to crinkle
or fold the back on itself. Insulate the window and replace all exterior trim
and casing.